Westerbeke 120D-TWO Manuale Utente Scaricare il pdf (Pagina 52)

Component Removal and Replacement

R500 - Laser

Table of Contents

Handle the laser with care! Do not bump or jar it.

1. Make sure the PLS is powered OFF and unplugged.

2. Press the two hinges to release the

latch on the backside of the PLS.

Gently fold back the rear cover.

3. Unplug the electrical connector from

the Laser by manually undoing the

two thumb screws and gently pulling

to the left.

4. Rotate the laser, a few degrees, from

the bottom and lift it up and off the

mounts. Store the Laser in a safe

place.

5. When reinstalling the Laser Tube

slowly rotate the laser cartridge

making sure that the alignment plate

is centered in the gap of the alignment

fork between the small and large

plates.

Note: The PLS6.60 and 6.120D have two laser tubes. The power connectors are

labeled “Top” and “Bottom”. It is very important that you plug in the correct connector

into the appropriate laser; otherwise the laser system will not function properly.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 71 72

Nessun commento

Westerbeke 120D-TWO Manuale Utente Pagina 52